How to Refill Your Diaper Genie Select Pail Step by Step

By Diaper Disposal Solutions - Diaper Genie | Published: 2026-10-19

Category: How-to Guides

Learn the exact steps to refill your Diaper Genie Select Pail, including common mistakes to avoid and how to get the best odor control from the stainless steel design.

Quick Answer

To refill your Diaper Genie Select Pail, open the lid, remove the old refill ring, insert a new square refill, thread the film through the cutter, and close the lid until you hear a click. Avoid twisting the refill bag before sealing to prevent jams.

Why the Select Pail Refill Is Different

The Diaper Genie Select Pail uses a square refill cartridge, not a round one like some other models. This means you cannot swap in a round refill and expect it to fit. The stainless steel body is durable, but the refill mechanism is what keeps odors contained. If you force the wrong refill type, the film may not seal properly, letting smells escape.

Common Refill Mistakes to Avoid

One frequent error is pulling too much film before closing the lid. This creates slack that can bunch up and cause the cutter to tear the bag prematurely. Another mistake is not pressing the refill ring down firmly until it clicks. A loose ring allows the film to slip, leading to leaks or odor. Finally, do not overstuff the pail—overfilling can strain the film and cause it to rip when you open the lid.

Step-by-Step Refill Instructions

Open the lid and remove the old refill: Press the foot pedal to open the lid. Lift out the empty refill ring by pulling it straight up. Dispose of the used refill cartridge according to local waste guidelines. If the ring is stuck, do not yank it—gently rock it side to side to loosen it.
Insert the new square refill: Take a new Diaper Genie Select square refill and align it with the opening inside the pail. Push down firmly until you hear a click, confirming it is locked in place. A missing click means the ring is not seated correctly; press again until it clicks.
Thread the film through the cutter: Pull the end of the refill film up through the center of the ring. Grasp the film and pull it out about 6–8 inches above the ring. Close the lid until it clicks shut. The internal cutter will automatically seal the film. Pulling too much film can cause bunching; 6–8 inches is enough for the first diaper.
Test the seal: Press the foot pedal to open the lid. You should see a sealed knot of film at the bottom of the pail. If the film is loose or not sealed, reopen the lid and pull a little more film, then close again until you hear the click. A loose seal means the cutter did not engage—reclose firmly until you hear the click.
Start using the pail: Place the first diaper into the pail. Press the foot pedal to open the lid, drop the diaper in, and close the lid. The film will automatically wrap the diaper. Repeat as needed. Avoid twisting the bag manually; the pail’s mechanism does it for you.

Product Facts

Diaper Genie® Select Pail: The Diaper Genie® Select Pail is made of durable stainless steel for long-lasting use and includes one starter square refill for immediate setup. The stainless steel construction resists dents and corrosion, so the pail stays functional even with daily use, and the included starter refill means you can begin using it right out of the box.
Diaper Genie® Select Pail